Unit M: Measurement in SI and imperial
Program of Studies title: Measurement
SI prefixes, imperial fractions, conversions, linear measurement, area, and surface area of right cylinders and cones. This is an independent resource aligned to the 2008 Mathematics 10-3 program. An independent project based on the Alberta Program of Studies, with no endorsement from Alberta Education.
Focusing questions
- How does a prefix move a measurement along the base-ten ladder?
- How do feet, inches, and the two gallon sizes describe the same job?
- How do perimeter, area, and surface area formulas use a measured length?
Key concepts from the Alberta curriculum
- SI base units and the prefixes milli through kilo
- Imperial length, capacity, mass, and temperature
- Proportional conversion between SI and imperial
- Perimeter, circumference, and shipping length
- Area of rectangles, triangles, circles, and composite shapes
- Surface area of right cylinders and right cones
Lessons by outcome
M1Lesson 1: SI prefixes and base units
A prefix moves an SI measurement along a base-ten ladder: 2.4 metres is 240 centimetres and 2400 millimetres, and 2.5 litres is 2500 millilitres.
General outcome: Measurement
M2Lesson 2: Imperial units and fractions
A tape measures 8 feet 3 inches as 99 inches, a US gallon holds about 3.8 litres, and a British imperial gallon holds about 4.5 litres.
General outcome: Measurement
M1, M2Lesson 3: SI and imperial conversion
One inch is about 2.5 centimetres on a layout and exactly 2.54 centimetres on a finished cut, and 20 degrees Celsius converts to 68 degrees Fahrenheit.
General outcome: Measurement
M3, A1Lesson 4: Linear measurement on the job
A pipe wall is half the gap between the outside and inside diameters, and a 6.5 metre by 2.0 metre mat has a perimeter of 17 metres.
General outcome: Measurement, Algebra
M4, G1, A1Lesson 5: Area of flat shapes
A 5 metre by 4 metre rectangle covers 20 square metres, and an L-shaped room is the sum of two rectangles.
General outcome: Measurement, Geometry, Algebra
M4, A1Lesson 6: Surface area of solids
A right cylinder's metal cover is two circles plus one rectangle, and a right cone uses the radius and the slant height.
General outcome: Measurement, Algebra